I.Make sure the board power is on and the port on board which connected to PC is USB blaster port. If yes, please install the USB blaster driver refer to this link: Altera USB Blaster Driver Installation Instructions

If Altera USB Blaster isn’t showed in Universal Serial Bus controllers, please check whether the Other devices has Unknown device.

If yes, users can use Quartus programmer and download FPGA code.

Power on the FPGA board and connect USB blaster port or USB blaster cable to PC.Ĭheck if the Universal Serial Bus controllers in the Windows Device Manager has an Altera USB Blaster.

This section describes users how to test whether the on-board USB blaster or USB blaster cable is properly installed and operated Using USB Blaster Under Linux USB Blaster Self Test Prime Signal Tap Logic Analyzer for logic analysis.Īltera_USB_Blaster_Driver_Installation_Instructions

You can also use the cable with the Intel Quartus The Terasic Download Cable and initiate the programming or configuration using To program or configure the device, connect the host system to the device board using System and set up the hardware in the Intel Quartus® Prime software. To start using the Intel FPGA Download Cable, user need to install the drivers on your Target power supplied by the device boardĭimension of the Terasic USB Download Cable The following picture and table list the pins of the Terasic Download Cable female plug andĭescribes their functions in the JTAG and passive serial modes.

Table 1‑4 Support Target board supply voltage Support Target board supply voltage

Altera usb blaster driver software